Leathercraft Tool

On 2/11/2011 5:06 PM, Tom wrote:
>
>
> How off is it?

When I try to plumb a 7" x 7-1/2" piece of leather, if I place one edge
on the bottom and trim the right side, then rotate the leather
90-degrees and repeat, after the fourth trim it should have 4 90-degree
angles, but if I continue to the fifth measurement, it angles in to
where there is about 3/16" at the top that still appears to need
trimming. I think 3/16" is quite a bit for a 7" run.

I never realized this before because I normally make all these kinds of
adjustments on the patterns before cutting. This time I was trying to
modify a cutting to be a little larger than the pattern and decided I'd
better make sure all the sides were square.

I don't mean square in the sense that all sides are the same length, but
that all sides are at 90-degree angles.

--
Dale Erwin
Lurigancho, Lima PERU
http://leather.casaerwin.org

=======
Email scanned by PC Tools - No viruses or spyware found.
(Email Guard: 7.0.0.21, Virus/Spyware Database: 6.16890)
http://www.pctools.com/
=======

------------------------------------

Free Leather Artisans Sharing a Hobby is the public list supported by the membership of the South Central Leather crafters Guild. It is just one of the ways we will support leather crafters and promote Leather craft. Membership in the guild is open to anyone interested in Leathercraft and Guild info can be found through the links section of this lists web site.Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/flasah/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/flasah/join
(Yahoo! ID required)

<*> To change settings via email:
flasah-digest@yahoogroups.com
flasah-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
flasah-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/